COMMANDS
45
SEndpac n (n = $00 – $FF)
default $0D All Units Packet
This command specifies a character that will force a packet to be sent in Convers Mode. In the
Convers Mode, packets are sent when the SENDPAC character is entered or when PACLEN is
achieved.
See also: cpactime, cr
SHift n (n = 170, 425, 850 or Modem)
default 170 KAM All Modes except CW
This command sets the default shift used in non-CW modes. When modem is specified, the MARK
and SPACE commands set the mark and space frequencies used. The modem tones are always se-
lected for Packet operation. Once you have entered a non-Packet mode, CTRL-C S can be used to
change shifts without affecting the SHIFT parameter.
See also: mark, space
SLottime n (n = 0 – 255) V 2.7
default 10
KPC-1/KPC-2/KPC-2400
Packet
default 5/10
KAM
Packet
default 10/10
KPC-4
Packet
n specifies the amount of time, in 10 millisecond increments, between successive tries of the per-
sistence algorithm.
See also: persist
SPace n (n = 50 – 4000)
default 1800 KAM All Modes except CW
This command sets the space frequency used when the SHIFT command is set to the modem or in
the Packet Mode. It also controls the bargraph space frequency indication.
See also: shift
STARt n (n = $00 – $FF)
default $11 (Ctrl Q) All Units All Modes
This command specifies the character sent by the computer to the TNC to restart input from the
TNC. If set to $00 only hardware flow control will be used. For software flow control, set this pa-
rameter to the character the computer will send to restart data flow.
See also: stop, xflow, xoff, xon
To Next Page
Loading...
