Kantronics KPC-2 - Page 48

BASIC terminal program for the 11۹-80 Model III
1 OUT 0
2 OUT232,164
3 OUT233,85
4 CLS
10 IF INP(234) and 128 then print CHR$(INP(235));:GOTO 10
20 A$=INKEYS$:IF A$="" THEN 10
30 IF INP(234)and 64 THEN OUT 235,ASC(A$): GOTO 10 ELSE GOTO 30
Put the TRS-80 Model III in BASIC. Type and run the program. When the program is
run the screen will go blank. At this time turn on the TNC. The TNC will send the
PRESS * FOR AUTOBAUD routine.
This program uses a 3-wire cable as described in the Connecting Your Computer
section. Wire only RXD, TXD and SG.
BASIC terminal program for the Apple computer with the
Super Serial Card
10 REM THIS PROGRAM SETS UP THE SSC FOR THE TNC
20 REM ASSUMES THE SSC IS IN SLOT $2
30 A$=CHR$(1):D$=CHR$(4)
40 PRINT D$;"PR#2"
50 PRINT A$;"6 BAUD":REM SET 300 BAUD
60 PRINT A$;"0 DATA":REM 8 DATA, 1 STOP BIT
70 PRINT A$;"0 PARITY":REM NO PARITY
75 PRINT A$;"SD":REM DISABLE SPECIAL CHARS & ENABLE ESC KEY
80 PRINT A$;"TERM MODE"
90 REM IN TERMINAL MODE-TALK TO TNC
100 REM PRESS<CTRL RESET>TO EXIT PROGRAM
110 PRINT A$;"RESET"
120 END
42 SAMPLE TERMINAL PROGRAMS
© Copyright 1989, Kantronics, Inc. All Rights Reserved.
Version 2.85 Duplication of this manual or the firmware without
Installation Manual permission of Kantronics, Inc. is prohibited.