Kantronics KPC-3 - User Manual

Details license terms including License, Term, Object Code, and Limited Warranty sections.

Covers general terms, governing law, export restrictions, and acknowledgement of terms.

Outlines warranty, remedies, exclusive remedy, and disclaimers of implied warranties.

Lists applicable hardware units and accessories with their warranty periods.

Details warranty exclusions, remedy procedures, and return policy.

Covers non-assignment of warranty and other legal rights.

Lists Kantronics TNC models and firmware versions being updated to 8.2.

Outlines topics covered in the addendum, including version summaries and differences.

Highlights key improvements in version 8.2 firmware, including new modes and command changes.

Introduces advanced digipeating capabilities and new commands for GPS/APRS applications.

Discusses how version 8.2 updates command sets for KPC and KAM models.

Details changes from version 7.0 to 8.2 for the KPC-3 Plus model.

Details changes from version 6.0 to 8.2 for the KPC-3 model, including MODEM mode.

Details changes from version 8.1 to 8.2 for the KPC-9612 Plus model.

Details changes from version 7.0 to 8.2 for the KPC-9612 model, including MODEM mode.

Details changes from version 8.0P to 8.2P for the KAM Plus model.

Details changes from version 8.0E to 8.2E for the KAM with Enhancement Board.

Discusses inefficiencies in generic digipeating and how version 8.2 addresses them with new commands.

Introduces new commands like UIDIGI, UIFLOOD, UITRACE, UIDWAIT, and UIGATE.

Demonstrates configuring three digis using the UIDIGI command for GPS/APRS.

Shows how to configure three digis using the UIFLOOD command for GPS/APRS.

Explains the updated UITRACE command with 'n' timer for digipeat control.

Demonstrates cross-band digipeating configuration using FLOOD and UIGATE commands.

Explains how to use MODEM mode to copy NWS EMWIN broadcasts.

Details the MODEM mode functionality for TNCs acting as dumb modems.

Step-by-step guide for installing the new firmware EPROM, including safety precautions.

Explains the UIDIGI command for setting up to four additional aliases for special digipeating.

Describes the UIDWAIT command for controlling delays on special digipeat packets.

Details the UIFLOOD command for multi-hop digipeating with reduced transmission time.

Explains the UIGATE command to prevent high-speed UI frame activity from congesting low-speed ports.

Details the UITRACE command for packet tracing and duplicate digipeat prevention.

Summarizes changes in version 8.2, including new, changed, and deleted commands.

Lists commands removed in version 8.2, such as LCSTREAM, MHCLEAR, and RESP.

Documents commands modified in version 8.2, like BUDLIST and SUPLIST.

Introduces commands added in version 8.2, including BREAK, MHEADER, and PBLIST.