KARA Pure - Precautions

Setup and Operaon
Remove the unit from the packaging and
place on the oor in desired locaon
which is close to a power outlet. Aach
supplied power cord to unit. Place unit
in a desired locaon close to a power
outlet and plug in the wall socket.
Verify that power buon is illuminated
and that LCD, located at the top of the
unit, is illuminated and displays the
humidity in the room. You should also
hear the fan start. If not, please refer to
troubleshoong secon.
Filters must be primed rst or water may
contain carbon or other loose parcles
from the lters. (See Filter Priming)
8 9
First Setup - WIFI
• Welcome screen
• Setup WIFI.
• Chose your access point
• Enter password
• You can skip WIFI setup
System Status Screen
1. On the status screen you can see the device
status and related informaon.
2. System status: Running or stopped.
3. System Error: In case of machine malfuncon
you can see possible a reason.
4. Wi status.
5. Hot water temperature. Factory set.
6. Filter status. Over me, lters should be
changed. You can see lter usage stasc and
a nocaon when it should be changed.
7. Ambient temperature and humidity.
Maintenance
Filter Replacement
1. Unlock and open the back door
2. Filters are located at the boom
3. “Water Sanitaon/Carbon” lter is on the
le and “Mineralizer” is on right
NOTE: the order of lters is important!
4. To remove lters, twist to the le and the
lter will detach
5. Replace old lter with new lter in the
cap and twist to the right
6. NOTE: Do not over-twist because cap
may become dislodged, damaged or it
may break.
Cleaning
Air lters need to be vacuumed or cleaned every
3 months. Ensure vents are free of dust and
debris.