Kärcher 1350 G User Manual

4
KÄRCHER 1350 G
4. Start-up
Unpacking the appliance
• Please contact your dealer immediately if, on
unpacking the appliance, you discover dama-
ge has been caused during transportation.
Fitting the accessories
• Press the spray lance into the hand gun against
the spring tension and turn it as far as the stop.
• The spray lance must lock into position.
• Screw quick coupler male to the water inlet
connection.
• Screw quick coupler female to your garden
hose.
• Tighten all union nuts hand-tight.
Engine
••
••
• Before starting the engine, read the operating
instructions of the engine manufacturer, paying
particular attention to the safety instructions.
Water connection
••
••
•
See Technical Data for connection values (see
chapter 3).
••
••
• Attach water supply hose to the appliance and
water main.
Water supply hose does not form part of
standard delivery.
••
••
• Before drawing water from an open container,
remove the coupler and screw a suction hose
with filter (order no. 4.440-238) onto the water
feed connection and place the end of the hose
in the water that is to be drawn in.
••
••
• Set the engine control to “SLOW” and allow the
pump to operate without the high-pressure
hose until water appears at the high-pressure
outlet without any more bubbles. Then re-
attach the high-pressure hose and set the
engine control to “FAST”.
– Never draw in water from a drinking
water tank.
– Never draw in liquids which contain
solvents, e.g. paint thinners, petrol, oil
and unfiltered water. The seals in the
appliance are not resistant to solvents.
The aerosol from solvents is highly
flammable, explosive and toxic!

Kärcher 1350 G Specifications

General

Brand	Kärcher
Model	1350 G
Category	Pressure Washer
Language	English