9
EN
Spray the glass surface evenly and from a
distance of 15–20 cm with as much liquid as
required without it running down the surface of
the window.
Remove the accumulation of dirt by wiping
over the surface with the felt strip.
Activate the vacuum system by pressing the
ON/OFF button on the main unit.
Draw the rubber blade over the glass surface
from top to bottom and at the same time apply
a small amount of pressure. The dirty water is
vacuumed off.
Complete the action by drawing the blade
sideways across the bottom edge of the
window, and then press the ON/OFF button
again to switch the vacuum system off.
Cleaning and storing the washer
Turn the dirty-water tank through 30 degrees
and pull it off downwards. Empty the tank.
!
The dirty-water tank should always
be emptied before the fresh-water tank is
refilled. Otherwise the water could
overflow and damage the unit.
Always recharge the battery overnight before
storing the Window Washer.
To Next Page
Loading...
