8
Attaching the accessories
First of all attach the detergent tank to the
cleaning head and then push the handle at
the end of the hose onto the cleaning head as
well. Ensure that it is connected the right way
round.
Insert the other end of the hose into the was-
her and secure with the threaded coupling.
Adding cleaning liquid
!
In order to avoid damage to equip-
ment or persons, do not under any
circumstances use detergents that
contain alcohol or produce foam.
If you intend to use a normal detergent
concentrate, please follow the
manufacturer’s instructions.
Cleaning liquids containing solvents may
reduce the service life of your appliance.
If there is any liquid left inside the
detergent tank, do not detach the handle from
the cleaning unit or the hose at the appliance
end, otherwise this liquid will leak out.
Remove the cap on the detergent tank and
insert the refill bottle into the opening.
Fill the tank and then replace the cap.
How to achieve the best cleaning results
– Do not clean a surface while it exposed to
direct sunlight.
– Dampen the fleece strip before you start
cleaning.
– Make sure you hold the cleaning head
handle the correct way. see Fig.
Spraying – Wiping – Vacuuming
!
Take care not to spray the water jet
into your eyes
Press the pump lever to spray water onto the
surface that is to be cleaned. It may be
necessary to press the lever a few times to
remove air from the system before water is
sprayed out of the nozzle.
To Next Page
Loading...
