Kärcher 140 - EU Declaration of Conformity; Unit Does Not Start up

10
Care and troubleshooting
Replacing the rubber blade and felt
strip
Rubber Blade and Felt Strip Set: (Order no.
2.883-341)
Replace the rubber blade whenever
stripes remain on the surface being
cleaned after it has been vacuumed. The
strip can be inserted from both sides and
used twice for greater economy.
To replace the rubber blade or felt strip: open
the slider on the cleaning head and remove
the cover.
Insert new rubber blade or felt strip.
Re-attach the cover, and lock in place by
closing the slider.
Unit does not start up
Check that battery is correctly inserted inside
unit.
Charge battery.
No spraying action
Check accessory attachments.
Check that there is water in fresh-water tank,
and refill if required.
Release air trapped in unit by pressing pump
lever several times.
Detach nozzle from cleaning head, and clean
carefully under running water.
No vacuuming action
Check accessory attachments.
Check that dirty-water tank is properly
attached.
Check that rubber blade is properly fitted.
Other fault symptoms
Any other faults should only be repaired by an
authorised service agent.
Dr. B. Graf
H. Jenner
S. Reiser
Alfred Kärcher GmbH & Co.
Cleaning Systems
Alfred-Kärcher-Str. 28–40
D-71349 Winnenden
EU Declaration of Conformity
We hereby declare that the equipment described below conforms to
the relevant fundamental safety and health requirements of the
appropriate EU Directives, both in its basic design and construction
as well as in the version marketed by us.
This declaration will cease to be valid if any modifications are made
to the machine without our express approval.
Product: Window cleaner with charger
Model: 1.084-xxx
Relevant EU Directives:
EU Machinery Directive (98/37/EEC)
EU Low-Voltage Equipment Directive (73/23/EEC), amended by
93/68/EEC
EU Directive on Electromagnetic Compatibility (89/336/EEC),
amended by 91/263/EEC, 92/31/EEC, 93/68/EEC
Harmonised standards applied:
DIN EN 60 335-1 DIN EN 60 335-2-29
DIN EN 60 335-2-54
DIN EN 55 014-1: 1993 DIN EN 55 014-2: 1997
DIN EN 61 000-3-2: 1995 DIN EN 61 000-3-3: 1995
National standards applied: -
Appropriate internal measures have been taken to ensure that
series-production units conform at all times to the requirements of
current EU Directives and relevant standards.
The signatories are empowered to represent and act on behalf of
the company management.