Kärcher B602 plus - Low Pressure Operation (With Brush)

11
We recommend the following cleaning method:
Step 1:
Remove loose dirt by washing over the surface to be cleaned
with the high pressure jet.
Step 2:
Spray on the detergent and leave for 1-4 minutes, so assisting
the easy removal of fine dirt and associated greasy adhesions.
Step 3:
Finally, spray off the loosened dirt with the high pressure spray.
4.3 Low Pressure Operation with Brush
When cleaning surfaces with a grease contamination - typically car
paintwork that always has a greasy traffic film covering adopt the
following procedure:
• Washing loose dirt away with the clean water high pressure spray.
• Apply the detergent in low pressure mode by setting the Four–Way
Nozzle (No.16) to the Low Pressure Jet (
).
• Leave for 2-4 minutes for the detergent to have maximum effect.
• Remove the bayonet fit spray lance and fit the Rotary Wash
Brush (No.17) to the Spray Gun (No.12). The Wash Brush is
suitable for use with a water inlet temperature into the Pressure
Washer of maximum 40 °C.
• With the pressure washer switched on, brush down the surface being
cleaned, this physical agitation removes all trace of traffic film.
• Finally revert to the high pressure operation with the Spray Lance
and complete the wash down.