To Next PageTo Next PageWhy Kärcher Floor Machine water volume is insufficient?
If the water volume of your Kärcher Floor Machine is insufficient, you should: Check the fresh water filling level and fill the tank if necessary. Increase the water volume at the water volume regulating knob. Clean the fresh water filter. Check the hoses for clogging and clean if necessary.
Why Kärcher Floor Machine cleaning results are unsatisfactory?
If you're not happy with the cleaning results from your Kärcher Floor Machine, try the following: Reduce the driving speed. Check the brushes for wear and tear, and replace them if needed. Also, make sure you're using the right brush type and detergent for the job.
Why Kärcher Floor Machine suction turbine runs at an increased speed?
If the suction turbine in your Kärcher Floor Machine runs at an increased speed, you should: Drain the waste water. Clean the float. Check the fluff filter and clean if necessary. Check the suction hose for clogging and clean if necessary. Check the suction bar for clogging and remove any clogging if necessary.
What to do if Kärcher Floor Machine brushes do not rotate?
General| Working Width (brush) | 800 mm |
|---|---|
| Working Width (vacuum) | 1000 mm |
| Tank Capacity (Dirty Water) | 100 l |
| Battery Voltage | 24 V |
| Brush Speed | 180 rpm |
| Battery Running Time | up to 4 h |
| Suction Motor | 550 W |
| Voltage | 24 V |
| Frequency | 50-60 Hz |
| Weight | 260 kg |
| Tank Capacity (Clean Water) | 100 liters |
| Brush Motor Power | 0.75 kW |
