Kärcher BR 30/4 C User Manual

– 8
waste water reservoir and the fresh
water reservoir prior to performing
maintenance on the appliance.
CAUTION
Risk of damage. Do not wash down the
appliance with water and do not use
aggressive detergents.
 Empty the waste water tank.
 Clean the seals between the waste
water tank and the appliance.
 Empty the fresh water reservoir.
 Rinse the appliance: Fill the fresh
water reservoir with clear water
(without detergent) and let the ap-
pliance run for one minute with the
brush water supply turned on.
 Empty the fresh water reservoir.
 Clean the outside of the appliance
with a damp cloth which has been
soaked in mild detergent.
 Clean the vacuum bar, check for
wear and replace if required (see
"Maintenance tasks").
 Check the brush for wear and re-
place if required (see "Maintenance
tasks").
 Have the prescribed safety inspec-
tion carried out by an electrician.
NOTICE
The vacuum bars are attached to the
appliance with snaps and can simply
be pulled off.
 Move the suction bar lift pedal to
position „suction off“ (Fig. 3 - posi-
tion "1/ON", see inside front cover).
 Remove the fresh water reservoir.
 Remove the waste water tank.
 Lay the device on the reverse.
 Pull off the vacuum bar downwards.
 Insert the new vacuum bars and
lock them into place.
 Remove the fresh water reservoir.
 Remove the waste water tank.
 Lay the device on the reverse.
 Press the release button for the
brush roller and swivel the brush
roller toward the bottom and pull it
off the driver.
 Place the new brush roller on the
driver and lock into place on the op-
posite side.
In case of danger of frost:
 Empty the fresh and dirt water res-
ervoirs.
 Store the appliance in a frost-pro-
tected room.
 DANGER
Risk of injury by inadvertent startup of
appliance and electrical shock.
First pull out the plug from the mains
before carrying out any tasks on the
machine.
CAUTION
Risk of damage to the appliance on ac-
count of water leakage. Empty the
waste water reservoir and the fresh
water reservoir prior to performing
maintenance on the appliance.
In case of faults that cannot be reme-
died using the table below please con-
tact the customer service.
Maintenance schedule
After the work
Yearly
Maintenance Works
Replace the vacuum bar.
Replacing the brush roller
Frost protection
Faults
10 EN

Kärcher BR 30/4 C Specifications

General

AC input voltage	220 - 240 V
AC input frequency	50 / 60 Hz
Maximum input power	820 W
Noise level	70.5 dB
Maximum area performance	200 m²/h
Fresh water tank capacity	4 L
Brush rotation speed (min)	1450 RPM
Practical area performance	150 m²/h
Brush contact pressure (min)	100 g/cm²

Weight and Dimensions

Depth	335 mm
Width	390 mm
Height	1180 mm
Weight	11500 g