What to do if the orange indicator lamp - Electronic brush control is ON on my Kärcher Pressure Washer?
If the orange indicator lamp for the electronic brush control is ON on your Kärcher Pressure Washer, adjust the pile height setting to a lower level using the adjustment knob.
What to do if the orange indicator lamp - Electronic brush control is also ON at lowest level on my Kärcher Pressure Washer?
If the orange indicator lamp for the electronic brush control is ON even at the lowest level on your Kärcher Pressure Washer, the brush likely needs to be replaced.
Why does my Kärcher Pressure Washer motor not run?
If the motor of your Kärcher Pressure Washer isn't running, start by checking the power supply. Ensure that the cables, plugs, fuse, and socket are all in working order and properly connected. Also, the motor may have been switched off by the thermostat due to overheating. In this case, pull the mains plug and inspect the filters and suction hose for any blockages. After the unit has cooled down, it should be operational again.
What to do if the red indicator lamp on the filter housing is ON on my Kärcher Pressure Washer?
If you notice the red indicator lamp on the filter housing of your Kärcher Pressure Washer is illuminated, it indicates a blockage. Clear any obstructions from the brush head, suction pipe, and suction hose. If the lamp remains on, replace the filter bag.
How to improve unsatisfying suction result of Kärcher Pressure Washer?
If you're experiencing an unsatisfying suction result with your Kärcher Pressure Washer, there are several things you can check: * Inspect the brush for any blocking objects. * Remove any obstructions from the brush head, suction pipe, and suction hose. * Replace the filter bag. * Replace the blower filter and motor protection filter. * Ensure the pile height adjustment knob is correctly adjusted. * If you have a CV 38/2 model, the brush may be worn out and need replacement. Compare the black bristles to the red indicator bundle to determine wear.
Identifies the appliance models CV 38/2 and CV 48/2.
Steps for cable release, handle adjustment, and positioning.
Instructions for connecting the power plug and activating the main switch.
Adjusting pile height and monitoring brush roller status indicators.
Vacuuming with the suction hose and securing the handle.
Steps for deactivating the switch, unplugging, and cable storage.
General| Motor power | - W |
|---|---|
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Maximum input power | 850 W |
| Annual energy consumption | 37.4 kWh |
| Airflow | 40 l/s |
| Product type | Upright vacuum |
| Dust capacity | 5.5 L |
| Product color | Black, Grey |
| Tube material | - |
| Dust container type | Dust bag |
| Standard nominal width | - mm |
| Noise level | 80 dB |
| Cleaning surfaces | Carpet |
| Vacuum air filtering | HEPA |
| Dirt separating method | Filtering |
| Working width (standard brush) | 380 mm |
| Cord length | 12 m |
Weight and Dimensions| Depth | 391 mm |
|---|---|
| Width | 351 mm |
| Height | 1215 mm |
| Weight | 9500 g |
| Weight (without accessories) | 8700 g |
To Next Page
