Why is my Kärcher Vacuum Cleaner suction too low?
If the suction of your Kärcher Vacuum Cleaner is too low, try these steps: * Replace the paper filter bag. * Check for blockages in the suction hose or suction channel and clean them if necessary.
What to do if suction turbine does not run in my Kärcher Vacuum Cleaner?
If the suction turbine isn't running in your Kärcher Vacuum Cleaner, check or replace the pressure switch and the suction turbine. Also, inspect the cable connections and repair any defects.
What to do if my Kärcher Vacuum Cleaner appliance cannot be started?
If your Kärcher Vacuum Cleaner won't start, ensure it's properly connected to the mains. Check the mains connection cable for any damage and replace it if needed. You may also need to check or replace the startup capacitor, the startup capacitor electronics, or the switch for the brush drive.
What to do if my Kärcher CV 66/2 has an insufficient cleaning result?
If your Kärcher Vacuum Cleaner isn't cleaning well enough, check the brush rollers for any foreign objects. Also, inspect the suction hose and suction channel for blockages and clean them if needed. Replacing the paper filter bag can also help. You might also need to check or replace the toothed belt.
General| Air Flow Rate | 48 l/s |
|---|---|
| Container Capacity | 30 L |
| Weight | 13.5 kg |
| Voltage | 220 - 240 V |
| Hose length | 2.5 m |
| Frequency | 50 - 60 Hz |
| Dimensions (L x W x H) | 880 x 540 x 1250 mm |
| Dimensions (L × W × H) | 880 x 540 x 1250 mm |
Details immediate danger that can cause severe injury or death.
Describes how the appliance is operated by pushing it on the handle.
Explains the brush roller and suction turbine function for dirt removal.
Details the location of switches and mains connection specifications.
Illustrates and lists the main components of the appliance.
Identifies components located on the underside of the appliance.
Lists available special accessories with their order numbers.
Provides general precautions and notes for disassembly and assembly.
Step-by-step guide to removing the appliance's operating panel.
Instructions for replacing a damaged mains cable or plug.
Procedures for completely replacing a defective appliance switch.
Guide to replacing the wire harness within the appliance.
Steps for dismounting the adjustable handle to access other parts.
Details the disassembly steps required to remove the appliance hood.
Instructions for removing the wheel from the appliance.
Guidance on lifting the appliance hood and dealing with potential obstructions.
Steps for replacing the drive belt connecting the motor to the brush roller.
Procedures for cleaning or replacing the suction channel cover and channel.
Instructions for replacing brush rollers when worn.
Steps for replacing a damaged toothed belt in the brush head gear.
Guide to replacing the entire suction turbine unit.
Steps for removing the brush head assembly from the appliance.
Instructions on how to remove the brush head height adjustment mechanism.
Steps for removing the microswitch that controls the brush motor.
Guide to replacing the pressure switch that monitors vacuum pressure.
To Next Page
