12 English
The suction turbine consists of 2 turbine motors in a casing. The
turbine unit must be completely replaced.
Î Remove the cover with filter basket
Î Remove the cover of the turbine coarse dirt filter, remove the
filter and clean it
Î The cover is mounted on spacer discs, these must be re-
moved and saved.
Î Loosen all 6 screws on the turbine unit
Î Remove the turbine unit
Î Disconnect the cable connection
Î Remove the turbine unit from the rubber tub
Î Guide the cable through the opening
Î Do not damage the rubber tub
Î Install the new turbine unit in reverse order.
Î Install the filter and filter cover - watch for the correct position
of the spacer discs
Î Install the cover with filter basket
Î Remove the appliance cover
Î Unscrew the fastening screws from the sides
Î Loosen the adjustment screws on the guiderail (1)
Î Pull away the holding angle (2)
Î The fastening screw (3) is free and can be removed.
5.12 Replace suction turbine
5.13 Remove the brush head.
To Next Page
