English 11
► Connect spray gun and pressure
hose.
► Open water source.
► Start the Engine.
1. Turn the engine switch to "ON"
position.
2. Move choke lever to "CLOSE"
position.
3. Turn the fuel valve to "ON" position.
4. Put the throttle lever to the "FAST"
position.
5. Pull trigger on spray gun to release
pressure.
6. Locate recoil cord and pull slowly
until resistance is felt. At this point,
pull rapidly to start engine.
7. After the engine has started, turn the
choke lever to "OPEN" position.
NOTE: If unable to start the engine,
repeat the above operation one or two
times.
NOTE: If the temperature is higher,
such as during summer or if the engine
is hot, choke valve should be switched
to "OPEN" position before starting.
To Next Page
Loading...
Need help?
General
