– 9
Basic settings
Note: The remote control is switched off when delivered. The remote control is turned on
by pressing any button.
Display when activated for the first time
or after changing the batteries
Standard display
Display in the startup stage (time has already
been set)
Setting the clock
Menu for setting time and day of
the week
Chapter 1
Page 97
Match sender
Menu for adjusting the frequency
between pump and manual sender.
Chapter 2
Page 98
Note:The manual transmitter is synchronised with the pump at the factory; you need to
make fresh settings only when you replace the manual transmitter.
Transmitter tuning can be done only within 30 seconds after connecting the pump; if
necessary, turn the pump off and back on again.
The distance to the pump must not exceed 5 m during the synchronisation.
The running synchronisation is signalled by repeated, brief starting of the pump.
If the display stops blinking "PAIr", the synchronisation is completed.
The successful synchronisation can be verified by manually starting the pump using
the "ON" / "OFF" buttons on the remote control.
To Next Page
Loading...
