Kärcher ICC 1 S D - User Manual

Questions and Answers

J
Jennifer RileySep 23, 2025
Why is there no fuel tank level indication on my Kärcher Floor Machine?
- K
  Kelsey MoodySep 23, 2025
  If there is no fuel tank level indication, check or replace the fuel level sensor B1.
R
Robert OliverAug 23, 2025
Why are the brushes on my Kärcher Floor Machine failing to rotate or rotating too slowly?
- H
  heather76Aug 25, 2025
  If the brushes fail to rotate or rotate too slowly, check the pressure in the working hydraulic circuit and adjust the pressure relief valve.
P
Peggy WalkerAug 25, 2025
What to do if the starter turns the engine but the Kärcher ICC 1 S D doesn't start?
- T
  Tanya JonesAug 26, 2025
  If the starter turns the engine but it fails to start, you should check the battery voltage. Also, verify the fuel level and top it up if needed. Furthermore, check and replace the fuel filter and air cleaner element. You may also need to check or replace fuses F12 and F1, the glow plug control module D1, the engine shutoff solenoid valve Y1, and the starter drive gear.
T
Troy GarciaAug 27, 2025
How to troubleshoot a Kärcher Floor Machine when the starter fails to turn the engine?
- J
  Justin MorganAug 27, 2025
  If the starter fails to turn the engine, you should check and replace fuse F1. Also, check the ground connection between the engine and chassis, and inspect the battery G1 for voltage, electrolyte level and density. Furthermore, check and replace the ignition switch S1. You may also need to check the voltage at the starter relay and terminals, and check or replace the starter.
A
andrewwhiteheadAug 27, 2025
What to do if the Kärcher ICC 1 S D Floor Machine engine cannot be shut off?
- W
  wrightericaAug 27, 2025
  If the engine cannot be shut off, you should check the engine shutoff control module D2. Additionally, check or replace the ignition switch S1 and the engine shutoff solenoid valve Y1.
J
Jonathan AllenSep 17, 2025
Why is the water pump not working on my Kärcher ICC 1 S D Floor Machine?
- R
  Robert StevensSep 18, 2025
  If the water pump is without function, check or replace fuse F5, relay K3, and water pump M2.
W
William SpencerSep 14, 2025
Why aren't the stop lights working on my Kärcher ICC 1 S D?
- C
  Cindy McdonaldSep 14, 2025
  If the stop light is without function, check or replace fuse F15 and stop light switch S19.
T
Tyler WelchSep 15, 2025
What should I do if the debris container on my Kärcher ICC 1 S D Floor Machine cannot be lowered?
- J
  Jennifer AllenSep 15, 2025
  If the debris container cannot be lowered, check and replace the valve on the control block. Also, switch off the side brushes.
B
Bobby HancockSep 6, 2025
Why is the blower not working on my Kärcher ICC 1 S D?
- V
  victorbarnesSep 6, 2025
  If the blower is without function, check or replace switches S10 / S11 on the debris container. Also, check or replace relay K1, fuse F4, check or adjust the V-belt and check the magnetic clutch.
E
elizabethalvarezSep 3, 2025
Why is my Kärcher Floor Machine not developing sufficient suction?
- B
  Becky ThomasSep 3, 2025
  If the machine fails to develop sufficient suction, check and clean the chain curtain in the debris container. Also, check the vacuum intake and impeller fan. Furthermore, check, adjust, or replace the sealing lips on the vacuum intake, check the vacuum intake condition and remove any blockage, check or replace the seal in the vacuum channel, and check, adjust, or replace the seals on the debris container.