3
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch
in diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS –
continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g. paint
thinners, gasoline, oil, etc.
• Always prevent debris from being drawn into
the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step1 Insert the Spray Wand Extension
into the trigger gun. Press in against the
spring tension and twist into the lock posi-
tion. Turn the Spray Wand Extension Collar
clockwise until tight.
Step2
Connect the detergent
suction tube to the pressure washer.
To Next Page
Loading...
