Why is my Kärcher K 3.540 Pressure Washer pump leaking water?
If your Kärcher Pressure Washer pump is leaking water (more than 10 drops per minute), ensure that all fittings are tight. If the leaking continues, it may indicate that the water seals are damaged or worn.
What to do if my Kärcher Pressure Washer has no detergent?
If your Kärcher Pressure Washer isn't dispensing detergent, start by checking the detergent suction tube connection to ensure it's properly connected to the machine. If the detergent is too thick, dilute it—using Kärcher® detergent is recommended for best results. Also, inspect the filter on the detergent suction tube for clogs and rinse with warm water to remove any debris. If the detergent suction tube is damaged or clogged, remove the obstruction or replace the tube. Lastly, make sure the spray wand is in the low pressure position and the discharge nozzle is not obstructed; if obstructed, blow out or remove debris with a fine needle.
What to do if garden hose connection leaks on my Kärcher K 3.540?
If the garden hose connection on your Kärcher Pressure Washer is leaking, first tighten the fittings. If the leak persists, check for a missing or worn rubber washer and insert a new one.
Why is my Kärcher Pressure Washer pump noisy?
A noisy pump in your Kärcher Pressure Washer often indicates that the pump is sucking air. To resolve this, check that all hoses and fittings are airtight. Then, turn off the machine and purge the pump by squeezing the trigger gun until a steady flow of water emerges through the nozzle.
What to do if my Kärcher K 3.540 spray wand leaks?
If your Kärcher Pressure Washer spray wand is leaking, ensure it is properly attached by inserting it into the trigger gun, pressing against the spring tension, and twisting it into the locked position. If the issue persists, it may be due to a broken o-ring or plastic insert, and you should call Customer Support.
General| Form factor | Upright |
|---|---|
| Hose length | 7.62 m |
| Power source | Electric |
| Product color | Black, Yellow |
| Maximum flow rate | - l/h |
| Maximum input water temperature | 40 °C |
| AC input voltage | 120 V |
| AC input frequency | 60 Hz |
| Surface cleaner | - |
Weight and Dimensions| Depth | 304.8 mm |
|---|---|
| Width | 330.2 mm |
| Height | 863.6 mm |
| Weight | 12247 g |
Slide the transport handle into the guide and secure it with 2 screws.
Insert the wheel into the body, rotating until it clicks. Secure with the enclosed plug.
To Next Page
