English 9
4. Remove the fine filter using the suc-
tion hose connection or suitable pliers.
5. Remove the fine filter from the suc-
tion hose connection.
6. Insert the suction hose connection
into the device and fix it in
place by
turning it 90°.
7. Hang the suction hose with integrat-
ed filter in the source of water (e.g.
in a water bucket).
ATTENTION
Loss of valve opener and fine filter
Operation of the device not possible
Keep the valve opener and the fine fil-
ter in the storage compartment.
Insert the valve opener and the fine fil-
ter before using the water reservoir.
Make sure that the pin of the valve
opener points upwards.
Operation
ATTENTION
Dry running of pump
Damage to the device
If the device does not build up any
pressure within 2 minutes, then switch
off the device and proceed according
to the instructions in chapter Trouble-
shooting guide.
1. Press the power switch.
2. Press the lever of the trigger gun.
Approx. 2 minutes before the en
d of
the operating time (see chapter Tech-
nical data), the charge level indicator
starts to flash.
a
b
To Next Page
