62 RLM 4GB
Malfunction Cause Remedy
Appliance vibrates or the
volume is too high.
Imbalance on the cutting
blade or in the cutting blade
drive
■
Clean the mower deck.
■
Contact a Kärcher service centre.
Rechargeable battery can-
not be charged or low bat-
tery voltage
■
The charging contacts of
the charging station are
dirty.
■
The contact surfaces on
the appliance are soiled.
Clean the charging contacts and contact
surfaces.
Charging station has no pow-
er.
Connecting the charging station to the
power supply.
■
The appliance does not
touch the charging con-
tacts.
■
The contact surfaces on
the appliance are burned
out.
■
Place the appliance in the charging
station and check that the charging
contacts make contact.
■
Contact a Kärcher service centre.
The service life of the re-
chargeable battery has ex-
pired.
Contact a Kärcher service centre.
The charging electronics are
faulty.
Contact a Kärcher service centre.
NOTE
If you encounter any malfunctions that are not listed in this table or that you cannot rectify
yourself, please contact our customer service.
13.2 Fault codes and troubleshooting
Fault code Cause Remedy
CN001: Tilt sensor The inclination sensor has
been triggered:
■
Max. tilt exceeded
■
The appliance has been
carried
■
Slope too steep
Place the appliance on a flat surface
and acknowledge fault.
CN002: Lift sensor The lift sensor has triggered:
■
The appliance cover has
been deflected upwards
by lifting or by an obsta-
cle.
Remove the obstacle.
CN005: Bumper de-
flected
The appliance has driven in-
to an obstacle and cannot
free itself (e.g. collision close
to the charging station).
■
Place the appliance on the free,
designated grass surface.
■
Correct the location of the boundary
cable.
To Next Page
Loading...
