SC 1122 English – 19
Window tool (E1)
Application:
– windows, mirrors, glass surfaces on shower
cubicles, other glass surfaces
• Apply steam to the glass surface from a
distance of approximately 20 cm until the
surface is moistened evenly.
• Strip the glass surface in straight lines from the
top to the bottom using the rubber lip of the
window tool.
• Wipe the rubber lip and the bottom edge of the
window dry after each strip.
Floor nozzle (G1)
Fields of application:
– all washable wall and floor coverings, e.g.:
stone floors, tiles, and PVC floors.
• Attach the floorcloth (G3) to the floor nozzle
(G1). Fold up the floorcloth lengthways, and
place the floor nozzle on the cloth. Pull the
jutting out ends of the floorcloths one after the
other under the retaining clips (G2) (see
Figure 3).
Figure 3: Attaching the floorcloth
• To remove the cloth, press the retaining clips
(G2), and pull out the cloth.
• Turn and exchange the floorcloth in regular
intervals. Doing so, you improve the
absorption of dirt.
• Work slowly on very dirty surfaces to allow the
steam to act on the dirt for a longer period of
time.
• If there are residues of detergents or floor-
cleaningproducts (e.g. wax, liquid polish) on
the surface to be cleaned, streaks may form
during the cleaning. These streaks normally
disappear after a repeated use of the steam
cleaner.
4. How to use the accessories 5. Troubleshooting
Faults often have simple causes which you can
rectify yourself with the aid of the following sum-
mary. In case of doubt or of faults or remedies
not mentioned here apply to the authorized cu-
stomer service.
Danger of electric shock!
Repair work on the unit can only be carried
out by the authorized customer service.
Long heating-up time
• Boiler is furred
Low steam / no steam
• Boiler is furred
Steam decreases during the work /
no steam
• No more water in the water reservoir
- Refill water
Steam switch cannot be pressed anymore
• Release the steam switch lock (B2)
To Next Page
Loading...
Need help?
General
