Kärcher SC 3 Upright EasyFix User Manual

English 11
Filling with water
The water reservoir can be filled at any
time.
ATTENTION
Material damage through an open
reservoir cover or an incorrectly
seated or loose water reservoir
Liquid can escape and damage the
floor covering if the water reservoir is
not correctly closed or the water reser-
voir is not correctly fitted in the device.
Take care to ensure that the water res-
ervoir cover is closed and the reservoir
is seated tightly in the device when the
water reservoir is full.
ATTENTION
Damage to the device
Unsuitable water can block the noz-
zles.
Do not use condensation from the
clothes dryer for filling.
Do not use collected rain water for fill-
ing.
Do not use detergents or other addi-
tives (e.g. scents) for filling.
Note
The decalcification cartridge must be
installed in the water reservoir when
filling the water reservoir.
Fill the water reservoir directly on
the device
1. Hold the device.
2. Open the reservoir cover and fill the
water reservoir directly on the de-
vice with MAX 17 oz. (0.5 L) tap wa-
ter.
3. Close the reservoir cover.
Removing the water reservoir for
filling
1. Hold the device.
2. Turn the lower cable holder up-
wards.
3. Pull the water reservoir vertically up-
wards by the handle.
4. Open the reservoir cover and fill with
MAX 17 oz. (0.5 L) tap water.
5. Close the water reservoir cover.
6. Insert the water reservoir and press
downwards until it locks into place.
MAX 17 oz.
(MAX 0.5 L)
MAX 17 oz.
1.
2.
3.
(MAX 0.5 L)

Kärcher SC 3 Upright EasyFix Specifications

General

Type	Steam mop
Capacity	0.5 L
Control type	Buttons
Product color	Black, Grey, Yellow
International Protection (IP) code	IPX4
AC input voltage	220 - 240 V
AC input frequency	50 - 60 Hz
Ready time	0.5 min
Steam pressure	- bar
Adjustable steam	Yes
Continuous steam performance	40 g/min
Cable length	5 m
Steam-ready light	-

Weight and Dimensions

Depth	314 mm
Width	207 mm
Height	1185 mm
Weight	3100 g