8English
a Fill 1 cap (approx. 0.68 oz. / 20 ml)
of detergent into the spray bottle.
b Pour clean water slowly into the
spray bottle up to the MAX mark.
3. Assemble the spray bottle.
a Put the suction nozzle on the
spray bottle.
b Screw the spray bottle onto the
suction nozzle.
c Fit the microfiber wipe cover on
the wiping attachment.
Operation
Starting operation
Observe the following points to prevent
streaks appearing:
● Only glide the squeegee blade over
the surface to be cleaned, do no
t
press too hard.
● Hold the device at the correct angle
to the surface to be vacuumed. The
distance between the lower end of
the device and the surface should
be approx. 4 in. (10 cm).
● Use only a KÄRCHER detergent be-
cause this is specially developed for
use with the device.
● Spray a sufficient quantity of windo
w
cle
aning detergent onto the surface
so that it is not too dry.
● Clean the squeegee blade regular
ly
(see chapter Cleaning the squee-
gee blade and suction nozzle).
● Replace the squeegee blade when
worn (see chapter Cleaning the
squeegee blade and suction noz-
zle).
● Do not perform cleaning work under
direct sunlight or when the weathe
r
is to
o hot.
1. Set the spray nozzle to the "ON" po-
sition.
2. Distribute detergent.
a Press the spray lever and spra
y
the window cleaning detergent
evenly onto the surface to be
cleaned.
b Loosen the dirt using the microfi-
ber wipe cover.
3. Set the trigger to the "ON" position.
The device switches on.
The LED lights up.
To Next Page
Loading...
