Manager Facilities
The manager code is normally used to carry out system management functions. It is used to allocate and
delete other user codes, test the system, view the event memory, etc.
On entry of the manager code in Day mode the keypad will display the first managers menu option
1) Set System?
The manager has 10 similar menu options. Use the and keys to move through the menus. To perform
a function press the ENTER key.
The manager code can be used to unset the system in the normal way. It can also be used to set the
system, but the procedure is slightly different to the normal user code.
MENU 1 - Set System
Menu 1 allows the manager to set the system. Go to this menu and press the ENTER key.
1) Set System?
The system will start to set as if a normal user code had been entered. The options available to the normal
user, such as part-set and omit, are available in the normal way.
MENU 2 - View Event Log
Menu 2 allows the manager to view the event log, which is a list of the last 200 events to occur. Go to menu
2 and press the ENTER key.
2) View
Event Log?
The keypad will display the last event to be logged. In the example here, 145 is the event number (events
are numbered 1 to 200), USER RESET is the description of the event.
145) USER RESET
09:36:21 19-Nov
The bottom line is the time and date that the event was logged. Use the and keys to move through the
event log. Press the ERROR key to return to menu 2.
Some events have additional information which can be viewed by pressing the ENTER key when the event
is displayed.
MENU 3 - Print event log
With the ADE Opus-42 printer connected it is possible to print out the entire event log.
With menu 3 on display press the ENTER key.
Printing...
ERROR to Stop
Karizma+ will start to print the event log, starting with the newest event first. Press ERROR at any time to
stop the printer.
To Next Page
Loading...