KARLSON TFTPYOVSSD - Installation

12
Installation
01
Make sure that . . .
• Take o and remove all packaging
materials and adhesive tapes from the
cooking compartment and the door before
operating the oven.
• Do not install the oven behind a
decoration or a furniture cover. This would
pose a risk due to overheating.
• Cutting operations on the furniture shall
be performed before the installation of the
oven. Remove any burrs. They may have
an adverse eect on the functioning of
electrical units.
• For safety reasons, direct contact of
the oven with electrical parts shall
be prevented when the installation is
complete.
• Parts that provide insulation and
protection shall be installed so that they
cannot be removed by using any tool.
• Rear compartment of the cabinet in the
kitchen unit shall be removed to ensure a
more ecient air circulation.
• We recommended you allow a minimum
clearance of 20mm from the rear of the
kitchen unit to where the oven is installed.
• We do not recommend installation of the
oven near a refrigerator or deep freezer.
Otherwise, the performance of such
appliances shall be aected adversely due
to the dissipated heat.
• Be careful not to damage the installation
BEFORE YOU INSTALL THE OVEN
holes by applying too much pressure on
the screws during installation.
• When a built-in hob is installed on the
counter above the oven, the electrical
cables of the oven and the hob should
be separated for safety purposes and to
facilitate the removal of the oven and hob
when necessary.