06
Safety
ELECTRICAL INSTALLATION
WARNING: This is a Class I
appliance and MUST
be earthed.
This appliance is supplied with a 3 core mains
cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
To avoid the risks that are always present
when you use an electrical appliance it is
important that this appliance is installed
correctly and that you read the safety
instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet
for future reference and pass it on to any
future owners. After unpacking the appliance
please check that it is not damaged. If in
doubt, do not use the appliance but contact
Customer Services.
The manufacturer declines all liability for
damage caused to persons and objects
due to incorrect or improper installation
of the appliance. Any permanent electrical
installation must comply with the latest
wiring regulations applicable to your country
and for your own safety a qualied electrician
or contractor should undertake the electrical
installation.
All installation must be carried out by a
competent person or qualied electrician.
Before connecting the mains supply ensure
that the mains voltage corresponds to the
voltage on the rating plate.
• If the current value of the switch in your
house is less than 16A, have a qualied
electrician install an 16A double pole
switch.
• Place the oven so that the outlet or double
pole switch used for power connection
may be reached easily.
• Do not place the power cord in contact
with hot surfaces and do not pinch it to the
product cover.
• The temperature of the power cord shall
not reach a temperature that is 50˚C above
the ambient temperature.
• Regularly check the power cord for
damage. If the supply cord is damaged, it
must be replaced with a new one with the
same dimensions and plastic insulation
and that may withstand the electrical
current required by the oven.
• Test the heating elements for 3 minutes
when the connection is complete.
• If the oven is to be connected directly to
the mains, a double pole switch suitable
for carrying the desired load as per the
current legislation and with a clearance of
3mm between its contact points shall be
installed between the oven and the mains.
The Earth wire shall not be cut o by the
double pole switch.
To Next Page
Loading...