46
This button activates and de-activates the wheelchair’s left/ right indicator.
Press the button to turn the indicator on and Press the button again to turn it
off. When activated the left indicator LED will flash in sync with the
wheelchair’s indicator(s).
⚫ LiNX Joystick Controller
To switch on the left indicator, press and hold the right-hand lighting button
once. The left turn signal will flash on and off. To switch on the right indicator,
press and hold the right-hand lighting button once. The right turn signal will
flash on and off.
12.3.12
Wheelchair lock
⚫ VR2 Joystick Controller
The VR2 control system can be locked to prevent unauthorized use. The
locking method is via a sequence of key presses and joystick movements, as
detailed below.
To lock the wheelchair:
Step1. While the control system is switched on, press and hold the on/off
button for more than 3 seconds. After one second the control system
will beep. Release the on/off button.
Step2. Push the joystick forwards until the control system beeps.
Step3. Pull the joystick in reverse until the control system beeps.
Step4. Release the joystick, there will be a long beep. The wheelchair is
now locked.
Use the on/off button to switch the control system on. The maximum speed /
profile indicator will be rippling up and down.
To unlock the wheelchair:
Step1. Push the joystick forwards until the control system beeps.