www.kart.pl
10
The controller is equipped with a real time clock. This clock allows turning the heating on, on selected weekdays. It is
possible to modify duration of every single washing programme, set the current time, program the timer which turns the
heating on, set the counter of washing processes, manually switch the heating on and off, and to select the language of
messages appearing on the display.
The display shows messages about current status of the machine - for instance: READY, BLOCKADE, EMERGENCY,
PROGRAM 1 and so on. When setting the parameters, the respective values appear on the display. Also, the current
date and time and the status of heating (ON or OFF) appears on the display.
The operation of the washer is controlled by the main switch, three washing buttons and the STOP button. Actuation of
the main switch SG turns the washer on. Upon pushing of one of three washing time buttons (20, 40 or 60 seconds) the
operating cycle starts (washing and blow-off). Pressing the STOP button interrupts the washing cycle, stops the pump
and automatically starts the 15-second blow-off cycle, which is signalled by lighting the LED diode.
HEATER THERMOSTAT - GENERAL VIEW AND PRINCIPLE OF OPERATION
OFF – heating is turned off
MIN°C – turning the heating on
MAX°C – maximum heating level
MIN°C - MAX°C – heating temperature range
The above operations can be performed only upon starting the programme in the controller.
NOTE! NEVER TURN THE HEATING SYSTEM ON
IF THE WASHING CHAMBER IS NOT FILLED WITH WATER TO THE REQUIRED LEVEL!
/OFF position/
To Next Page
Loading...