KAS Neo - Lock Operation Modes; Delete All User Cards; Set Standard Opening Mode; Set Dual Entry Opening Mode

6
5 Delete ALL User Card
1. Delete ALL RFID Tags from the lock for remove door access.
2. The RFID Tag must exist in the lock for successful deletion.
Format: “* * <Management Code> # 444 # “
Example: “* * 888888 # 444 # ”
Successful setting: 1 long beep, Will exit programming mode automatically
Unsuccessful setting: 2 short beeps
6 Set Opening Mode
1. There are two Opening modes. 1) Standard Mode – one step entry 2) Dual Entry Mode – two step entry.
2. Standard Mode: either pin code or RFID will grant access
3. Dual Entry Mode: Both RFID and Pin code are required for access.
4. Note: to be able to enable Dual Entry Mode you need at least 1 RFID tag and 1 user pin code already
programmed.
Set Opening Mode: Standard Mode [DEFAULT MODE]
Format: “* * <Management Code> # 141 # “
Example: “* * 888888 # 141 # ”
Exit programming mode by pressing “ * * “
Set Opening Mode: Dual Entry Mode
Format: “* * <Management Code> # 142 # “
Example: “* * 888888 # 142 #”
Exit programming mode by pressing “ * * “
7 Enable Free Passage
To ENABLE Free Passage:
• During the unlocking action, the green LED will be displayed. Press and hold # button for 3 seconds,
when the green LED is display. After 3 seconds, a rising tone will sound to signify that free passage is
enabled.
To DISABLE Free Passage:
• Any at time, press * button for 3 seconds, the lock will revert to locked state.
8 How to Factory Reset
1. This will erase all lock data and default Management Code to “888888”.