Tire Changer KT-830 User’s Manual
29
Stage of Inflation
BEAD SEALING
◇ Position valve stem in front of operator and connect the inflation hose after removing
the valve core.
◇ Step on the inflation pedal to allow air to flow into the tire and seal the beads.
THIS OBJECT IS A RESTRAINT DEVICE ONLY. IT WILL NOT PROTECT OPERATORS
IN THE EVENT OF CATASTROPHIC TIRE/WHEEL RUPTURE OR FAILURE. ALWAYS
USE EXTREME CAUTION DURING THE INFLATION PROCEDURE. AS AN ADDED
SAFETY PRECAUTION, SAFETY CAGES THAT CONFORM TO OSHA STANDARD
1910.177 ARE RECOMMENDED.
THIS MACHINE IS NOT INTENDED TO BE A RESTRAINING DEVICE FOR
EXPLODING TIRES, TUBES, OR RIMS. KEEP HANDS AND BODY CLEAR AT ALL
TIMES AND AS FAR BACK AS POSSIBLE DURING INFLATION. DO NOT LEAN OVER
THE TIRE WHILE INFLATING. AN EXPLODING TIRE, RIM OR OTHER WHEEL
COMPONENT CAN CAUSE DEATH TO OPERATOR AND/OR BYSTANDER. REMAIN
CLEAR AT ALL TIMES.
To Next Page
Loading...
