W H E E L B L A N C E R
- 7 -
4.2.2 Reverse p o s i tio n i n g
Spindle - spring - fit cone (big head inward)- wheel - quick nut
4.2.3 Special flange positioning
Fix the large flange to the matcher - wheel - large cone - quick nut
4.3 Size of the input
4.3.1 Input steps:
Ⅰ First enter the size "a"
This positioning method is suitable for the
wheel center hole Φ148 below the tire
installation.
Note: the choice of cone should be adapted to the center hole of the rim, and pay
attention to its direction, otherwise it will cause inaccurate measurement.
When the wheel outside deformation is large,
the reverse positioning is used to ensure the
accurate positioning of the inner hole and spindle
of the steel ring. It is suitable for steel ring,
especially for measuring thick aluminum alloy
ring.
The distance measuring ruler of the machine itself is used to
measure the distance between the body of the balancing machine
and the rim of the inner edge "A" value
Increase by the value []; Decrease by [-]
To Next Page
Loading...
