W H E E L B L A N C E R
- 8 -
Note: use automatic pull feet enter A value, in '0 bit position, pull the pull rod,
the pull end, roof and the tire along, stop for A few seconds, until the left side of
the display window shows the three rung, back on the pull rod, the pull rod
position, at this time on the left side of the digital tube display the value of
reference for the pull rod input size A value, on the right side of the value of
digital tube display is the wheel diameter size D value of reference. If the size
value flashes, the ruler does not return to zero position.
II Then enter the size "b"
III Then enter the size "d"
Note: If the radar width measuring device is available, the machine will
automatically measure the width B value of the tire at the same time as the
protective cover is lowered, without the need to manually input the size
"B".
Measure rim width "b" with width caliper
Increase by the value []; Decrease by [↓]
Until the measured "B" value is displayed
Find the nominal diameter "D" marked on the tire.
Increase by [+]; Decrease by [↓]
Until the set "D" value is displayed
To Next Page
Loading...
