INTRODUCTION
Congratulations on your purchase of the advanced RC set KAVAN V20. We hope you‘ll enjoy many hours of undistur-
bed fun with it in the utmost comfort. The V20 is a 24-channel RC set using a 2.4GHz simultaneous dual frequency
transmission system with full telemetry support (Twin 2.4GHz). It boasts a superior response time of up to 4ms,
and a range of up to tens of kilometres. You can choose ACCST D16 or ACCESS transmission systems too, also with
telemetry. The V20 can therefore be paired with a wide range of KAVAN or FrSky receivers, telemetry or not, with
classic PWM and S.BUS outputs. It is suitable for both advanced and sport pilots. Excellent for controlling various
aircraft models or heli/multicopters. It can also be easily set up for boats or land models. To do this, use the wide
range of functions and mixes available in the ETHOS™ operating system. You can conveniently adjust these to your
own preferences on the large colour touchscreen.
If you have any questions about the V20 transmitter and its operation, please contact the technical and service staff
at KAVAN Europe s.r.o. by e-mail (info@kavanrc.com for general technical information, service@kavanrc.com
for service) or by phone (+420 466 260 133 for general technical information, +420 463 358 700 for service), during
working hours 8 am–4 pm CET, Monday to Friday).
TECHNICAL SPECIFICATIONS
• RF protocol: 2.4GHz simultaneous on two frequen-
cies (Twin 2.4GHz)
• Antenna: two built-in 2.4GHz antennas
• Dimensions: 221.5×214.5×94 mm (W×H×D)
• Weight: 1027 g (including battery)
• Operating system: ETHOS™
• Internal RF module: TW-ISRM
• Channels: up to 24
• Operating voltage range: 6.5–8.4 V (2S LiPo
battery)
• Operating current: 240 mA at 7.4 V
• Operating temperature: (-10)–60 °C
• Operating frequency: 2,400–2,4835 GHz
• Max. radiated power: 100 mW EIRP
• Charging current: ≤1 A ± 200 mA
• USB adapter voltage: 5 V + 0.2 V
• USB adapter current: >2.0 A
• Display: backlit touch LCD with 800×480 resolution
at 4.3“ diagonal
• Compatibility: ACCST D16 / ACCESS
FEATURES
• Colour backlit LCD touchscreen at 4.3“ diagonal with 800×480 px resolution
• Up to 20 flight modes for perfect control of your model in all conditions
• Full telemetry with data transmission from a wide range of sensors with the ability to write to an SD card
• Memory for 64 models expandable via SD card
• Voice telemetry output from the speaker or via cable with a 3.5mm Jack connector
• Up to 2 external antennas can be connected
• 6 three-position switches, 2 two-position (1 momentary) switches
• 2 rotary side dials, 2 momentary buttons on the rear
• 6 user-programmable buttons (front)
• 2 programmable mixer rotary knobs
• 4 digital trims
• Programmable slider (sliding potentiometer)
• 6-axis gyro sensor
• Precision gimbals housed in 10 ball bearings
• Trainer mode via cable or wirelessly via Bluetooth®
• F.BUS port for programming servos
• Model names with 15 characters
• Subtrims
• Reversing the servo operation
• Setting end points and rate limiting
• Servo speed setting
2
To Next Page
Loading...
