Need help?Do you have a question about the KBL megaSun 5600 and is the answer not in the manual?
General| Brand | KBL |
|---|---|
| Model | megaSun 5600 |
| Category | Tanning Beds |
| Voltage | 400V |
| Frequency | 50Hz |
Lists essential safety guidelines and prohibitions for unit operation and maintenance.
Instructions for connecting the unit to the mains power supply, including safety warnings.
Crucial safety warning about UV radiation, protective eyewear, and skin sensitivity.
Tanning time recommendations based on skin type for the CPI (Level 1) model.
Tanning time recommendations based on skin type for the Inductive (Level 1) model.
Tanning time recommendations for Super Power & Ultra Power Inductive (Level 1) models.
Critical warning about excessive UV radiation causing severe skin and eye injuries.
Safety warning regarding UV radiation causing skin and eye injuries.
Explains the "EXHAUST AIR" error message and its possible causes.
Information on accessing service levels I and II via PIN codes and navigation.
Explains navigation within the service menu using buttons 5, 0, START, and STOP.
Initial steps to start the KBL5 service menu and enter PIN I.
Displays and resets the operating hours for WORK and TUBE.
Process for entering PIN II to access functions like C'M'A'B'.
Procedure to reset the tube operating hours.
Displays operating hours (WORK, TUBE) and temperature information.
Instructions to reset tube operating hours for inductive and CPI devices.
Steps to enter PIN II for accessing menu level PIN II.
Displays system operating hours, tube hours, and temperature.
How to view the total operating hours of the tanning unit.
How to view the operating hours of the tanning tubes.
Procedure to reset tube operating hours after replacement.
Switching specific functions like Channel, Music, Air-conditioning, and Facial Tanners on/off.
Presetting the air-conditioning unit, adjusting fan speed (OFFSET, A.START).
Procedure to enter the operating hours for the tanning tubes.
General guidelines for cleaning the unit, including safety precautions and cleaning fluids.
Lists cleaning agents that should not be used due to potential damage.
Describes the safety feature of protective pane-switches for facial tanners.
Steps to dismantle canopy, bed, side panes, and tube covers for cleaning/replacement.
Guidelines for replacing tubes, tanners, starters, and resetting counters.
Steps for replacing sunlamps after 600 hours, including safety notes.
Safety warning about handling P2 tubes and their retaining clamp.
Steps for removing tanning lamps, including filter panes and bulb extraction.
Guidelines for installing new lamps, ensuring proper seating and contact.
Lists specific error messages, their descriptions, and recommended remedies.
Error message for exceeding maximum tanning time and its remedy.
Error messages indicating low or expired aquaCool levels and remedies.
Error messages for defective boards, I2C bus faults, and sensor issues.
To Next Page
