P30 Update via USB
Software Update Instructions V1.14
10
© KEBA
5 Update via USB
The following steps are necessary for an update via USB:
● Remove covers
● Perform update
● Mount covers
5.1 Remove covers
The USB interface is located in the connection panel of the charging station.
To make the USB interface accessible, the housing cover and the connec-
tion panel cover must be removed. Proceed as follows:
1) Unscrew the two screws on the bottom of the housing
cover 1.
2) Lift the housing cover at bottom max. 1 cm 1 and then
push upwards 2.
3) Unscrew the four screws of the connection panel cover 1
and remove the connection panel cover upwards.
To Next Page
Loading...
