P30 Update via USB
Software Update Instructions V1.14
11
© KEBA
The USB interface USB in the connection panel is now ac-
cessible.
5.2 Perform update
An empty USB stick formatted with FAT32 is required.
To perform the software update via USB, proceed as follows:
1) Create a new directory on the USB stick with the name "UPD".
2) Copy the software update file "P30x_SW_[x_xx].keb" into the directory
"UPD".
3) Connect the USB stick to the USB interface of the charging station.
4) The update starts automatically. The display shows "USB...Updating
P30x_SW_[x_xx]".
5) Wait until all software components have been updated.
The update process is indicated by orange pulsing of the LED bar.
6) Unplug the USB stick when the display shows "Remove USB".
The update will continue even after the USB stick is disconnected.
7) At the end of the update, the versions of the installed software compo-
nents can be seen in the web interface. These versions can be com-
pared with the information in the "Software Release Notes".
8) After the software update, the charging station restarts automatically.
The LED bar flashes blue or green, depending on the authorization set-
ting.
Caution
During the software update, the power supply must not be interrupted under
any circumstances and the charging station must not be restarted. Other-
wise the software update will not be completed correctly and normal opera-
tion of the charging station is no longer guaranteed.
5.3 Mount covers
In order to operate the charging station correctly, all covers must be inserted
and screwed tight. Proceed as follows:
To Next Page
Loading...
