P30 Update via USB
Software Update Instructions V1.14
12
© KEBA
1) Insert connection panel cover 1 and tighten with 4
screws with 2 Nm. The tabs on the connection panel cover
must be flush with the enclosing housing. Only then will the
device be properly sealed.
2) Hook in the housing cover at the top 1 and close it at the
bottom 2. The housing cover must glide into the guides
without considerable resistance. The housing cover must
be correctly seated in the housing guide on all sides.
3) Fix the housing cover 1 with 2 screws at the bottom.
4) Check that the charging station is functioning properly.
To Previous Page
Loading...
