Explanation
of
Graphical Symbols
The lightning flash
with
arrowhead symbol. within
an
equilateral triangle,
is
intended
to
alert
the
user
to
the
presence
of
uninsulated "dangerous
voltage" within
the
products enclosure
that
may be
of
a sufficient
magnitude
to
constitute a risk
of
electrical shock
to
perscns.
The
exclamation mark within
an
equilateral triangle
is
intended
to
alert
the
user
to
the
presence
of
important
operating and maintenance (servici
ng
)
instructions in
the
literature accompanying
the
appliance.
CotTect Disposal
of
This Product. This marking indicates
that
this
product
should
not
be disposed
with
other
household wastes
throughout
the
EU
.
To
prevent possible harm
to
the
environment
or
human health
from
uncontrolled waste disposal, recycle
it
responsibly
to
promo
te
the
sustainable reuse
of
material resources.
To
retum
your
used device, please use
the
returri and collection systems
or
contact
the
retailer
where
the
product
was purchased. They can take this
product
for
environmentally
safe
recycling.
The
normal function
of
the
product
may be disturbed by Strong Electro Magnetic
Interference.
If
so,
simply reset
the
product
to
resume normal operation by following
the
instruction manual.
In
case
the
function could
not
resume, please
use
the
product
in
other
location.
FCC
Compliance Information
This device complies
with
part
15
of
the
FCC
Rules.
Operat
ion
1s
subject
to
the
following
two
conditions:
(I
) This device may
not
cause harmful inte
rf
erence,
and
(2.)
This device must accept any interference
rece1ved,
including interference
that
may cause undesired operation.
This equipment
has
been tested and found
to
comply
with
the limits
for
a
Class
B
digital device, pursuant
to
Part
15
of
the
FCC
Rules.
These limits are designed to
provide reasonable
protection
against harmful interference in a resident
ial
installation.
This
equipment
generates,
uses
and
can
radiate radio frequency energy and,
if
not
installed and used
in
accordance
with
the
instructions, may cause harmful interference
to
radio communications. However,
there
is
no
guarantee
that
interference will
not
occur
in a particular installation.
If
this equipment does
cause
harmful inte
rf
erence
to
radio
or
television reception, which can be determined by
tuming
the
equipment
off
and on,
the
user
is
encouraged
to
try
to
correct
the
interference by one
or
more
of
the
following measures:
- Reorient
or
relocate
the
receiving antenna.
- Increase
the
separation
between
the
equipment and receiver.
3
To Next Page
Loading...
