Keithley 2001-TCSCAN - Page 95

Index
B
Basic front panel operation 3-18
Block diagram 4-13
C
Calibration 4-10
Calibration with thermistor probe 4-10
Calibration with thermocouple wire 4-11
Card configuration 2-2
Card connections and installation 2-1
Card connectors 2-3
Card installation and removal 2-10
Channel resistance 3-31
Closing and opening channels 3-9
Closing channels 3-9
Component layout and schematic diagram 5-1
Configure channels (CONFIG-CHAN) 3-4
Configure stepping and scanning 3-18
Connections 2-1
Contact potential tests 4-5
D
Dressing leads 2-4
E
Environmental conditions 4-2
F
Factory service 5-1
Features 1-1
Front panel scanner controls 3-2
Front panel scanning 3-9
G
General information 1-1
Ground loops 3-32
H
Handling and cleaning precautions 4-1
Handling precautions 1-2, 2-1, 4-1
I
IEEE-488 bus scanner commands 3-6
IEEE-488 bus scanning 3-10
IEEE-488 programming example (temperature
measurements) 3-15, 3-23
Inspection for damage 1-2
Instruction manual 1-2
Isolation tests 4-8
K
Keeping connectors clean 3-33
M
Magnetic fields 3-31
Manual addenda 1-2
Manual scanning 3-6
Measurement considerations 3-30
O
Open and close channels (CHAN) 3-2, 3-19
Opening channels 3-9
Operation 3-1
Optional accessories 1-3
Ordering information 5-1
Output connections 2-4
Output connections to multimeter 2-12
P
Parts lists 5-1
Path isolation 3-31
Path resistance tests 4-4
Performance verification 4-2
Power-on safeguard 4-14
Power-up detection 3-2
Principles of operation 4-13
i-1