F-10 1 = ON
USB/GPIB setting
Rear Panel USB Mode F-22 2 = USB CDC
GPIB address F-23 8
LAN setting
LAN F-36 1 = Enable
DHCP F-37 1 = Enable
Sockets active F-57 1 = Enable
Web Server active F-59 1 = Enable
Web password active F-60 1 = Enable
Web setting password F-61 0000
Power On Configuration
CV Control F-90 0= Panel control (local)
CC Control F-91 0= Panel control (local)
Power-ON Output F-92 0 = OFF at startup
Master/Slave F-93 0 = Master/Local
External Out Logic F-94 0= High ON
Power Switch trip F-95 0 = Enable
The factory settings can be recalled by using the *RST or SYSTem:PRESet
commands. Note that the power needs to be cycled before the factory
settings for the USB, GPIB, LAN and Power On Configuration settings
can take effect.
To Next Page
Loading...
