2260B Series Programming Manual
24
2. Press the Function key to enter the
Normal configuration settings.
Page 9
Set the following LAN settings:
F-36 = 1 Enable LAN
F-37 = 1 Turn DHCP to enable
F-59 = 1 Turn the web server on
Note
It may be necessary to cycle the power or refresh
the web browser to connect to a network.
Sockets Server Configuration
Configuration
This configuration example will configure the
2260B for web sockets control.
The following configuration settings will manually
assign the 2260B an IP address and enable web
sockets. By default, the socket port number is 2268
and cannot be configured.
1. Connect an Ethernet cable from the
network to the rear panel Ethernet
port.
2. Press the Function key to enter the
Normal configuration settings.
Page 9
3. Set the following LAN settings:
F-36 = 1 Enable LAN
F-37 = 0 Disable DHCP
F-39 = 172 IP Address part 1 of 4
F-40 = 16 IP Address part 2 of 4
F-41 = 5 IP Address part 3 of 4
F-42 = 133 IP Address part 4 of 4
F-43 = 255 Subnet Mask part 1 of 4
F-44 = 255 Subnet Mask part 2 of 4
F-45 = 128 Subnet Mask part 3 of 4
To Next Page
Loading...
