SAFETY INSTRUCTIONS
3
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General Guideline
CAUTION
• Do not place any heavy object on the
instrument.
• Avoid severe impact or rough handling that
leads to damaging the instrument.
• Do not discharge static electricity to the
instrument.
• Use only mating connectors, not bare wires, for
the terminals.
• Do not block the cooling fan opening.
• Do not disassemble the instrument unless you
are qualified.
(Measurement categories) EN 61010-1:2001 specifies the
measurement categories and their requirements as follows. This
instrument falls under category II.
• Measurement category IV is for measurement performed at the
source of low-voltage installation.
• Measurement category III is for measurement performed in the
building installation.
• Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
• Measurement category I is for measurements performed on
circuits not directly connected to Mains.
Power Supply
WARNING
• AC Input voltage range: 85VAC~265VAC
• Frequency: 47Hz~63Hz
• To avoid electrical shock connect the protective
grounding conductor of the AC power cord to
an earth ground.
To Next Page
Loading...
