Front panel aspects of GPIB operation ................................................................... 7-8
Programming syntax ............................................................................................... 7-9
8 Status Structure
Overview ................................................................................................................ 8-2
Clearing registers and queues ................................................................................. 8-4
Programming and reading registers ........................................................................ 8-5
Programming enable registers ......................................................................... 8-5
Reading registers ............................................................................................. 8-5
Status byte and service request (SRQ) ................................................................... 8-6
Status byte register .......................................................................................... 8-7
Service request enable register ........................................................................ 8-8
Serial polling and SRQ .................................................................................... 8-8
Status byte and service request commands ..................................................... 8-9
Status register sets ................................................................................................ 8-10
Register bit descriptions ................................................................................ 8-10
Condition registers ........................................................................................ 8-17
Event registers ............................................................................................... 8-17
Event enable registers .................................................................................... 8-18
Programming example — program and read measurement event register ... 8-19
Queues .................................................................................................................. 8-19
Output queue ................................................................................................. 8-20
Error queue .................................................................................................... 8-20
Programming example — read error queue .................................................. 8-21
9 Common Commands
Overview ................................................................................................................ 9-2
Command notes (IEEE-488.2 common commands and queries) ................... 9-3
10 Signal Oriented Measurement Commands
Overview .............................................................................................................. 10-2
Command notes (Signal oriented measurement commands and queries) ..... 10-3
11 DISPlay, FORMat, and SYSTem
DISPlay subsystem ............................................................................................... 11-2
Command notes (SCPI commands — display) ............................................. 11-2
FORMat subsystem .............................................................................................. 11-4
Command notes (SCPI commands — data format) ...................................... 11-5
:SYSTem subsystem ............................................................................................. 11-7
Command notes (SCPI commands — system) ............................................. 11-8
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
