HP 85
The following program obtains one reading from the Model 617 Etec-
trometer and displays the reading on the HP-65 CRT screen, using the
62937A GPIB interface and an l/O ROM.
DIRECTIONS
1. Using the front panel program feature, set the primary address on the
Model 617 to 27.
2. Connect the Model 617 to the HP82937A IEEE interface.
3. Enter the following program using the END LINE key efter each line is
4. Depress the RUN key.
5. The display will read “TEST SETUP”.
6. To program the Model 617 to the &A range and take a reading, type
in FlR7TlX and depress the END LINE key.
7. The display will read NDCA + O.OOOOOE - 06 when the Model 617 is
in zero check.
PROGRAM
COMMENTS
10 DIM A9f251, Bsf251
20 REMOTE727
30 DISP ‘TEST SETUP”
40 INPUT’BS
50 OUTPUT 727;B$
64 ENTER 727;A$
70 DISPAS
80 GO TO 30
90 END
Set to remote.
Prompt for test setup.
Program the 617
Get data from 617.
Repeat
NOTE: If conversion to numeric variable is needed, change line 70 as
follows:
70 DISP VALfASI511
46
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
