Model 6517A Getting Started Manual Front Panel Operation 1-7
4 2V ANALOG OUTPUT
Binding post provides a scaled 0 to 2V output that is referenced
to COMMON. Typically connected to a measuring device such as a chart recorder. See
the Model 6517A User’s Manual for more information.
5 COMMON
Binding post that is internally connected to INPUT low through a 0.6
Ω
resistor.
6 CHASSIS GROUND
Binding post that connects the chassis to ground through the power
line cord. COMMON can be connected to chassis ground by installing the ground link.
For floating measurements, make sure the ground link connection between COMMON
and Chassis Ground is open.
7 HUMIDITY
Connect the optional Model 6517-RH probe for relative humidity
measurements.
8 V-SOURCE HI and LO
Banana jacks for the voltage source.
9 LINE VOLTAGE SWITCH
Two-position slide switch configures instrument for available
line power voltage. A 90 to 125V line voltage requires the 115V setting, while a 180 to
250V line voltage requires the 230V setting.
10 POWER LINE INPUT
Connect to power line (50 or 60Hz) grounded outlet using 3-wire
power cord.
11 LINE FUSE
For the 115V line voltage setting, use a
½
A, 250V, slow blow, 5
×
20mm fuse.
For the 230V setting, use a
¼
A, 250V, slow blow, 5
×
20mm fuse.
12 IEEE-488 CONNECTOR
Connects the instrument to the IEEE-488 (GPIB) bus. Use
shielded IEEE-488 cables.
13 TRIG LINK
An 8-pin micro DIN connector for sending and receiving trigger pulses to
and from other instruments.
14 DIGITAL I/O
An 8-pin micro DIN connector for the four TTL-compatible digital output
lines.
15 RS-232
DB-9 connector for the RS-232 interface. Use a standard RS-232 cable.
16 INTERLOCK
Connects the safety interlock to the Model 8009 Resistivity Test Fixture or
the Model 8002A High Resistance Test Fixture using the appropriate cable.
17 OPTION SLOT
An option card, such as the Model 6521 or 6522 scanner card, installs
in this slot.
To Next Page
Loading...
Need help?
General
