To Next PageTo Next Page
Need help?Do you have a question about the Keithley 6221 and is the answer not in the manual?
General| Interface | GPIB, RS-232 |
|---|---|
| Communication Interface | GPIB, RS-232 |
| Current Sourcing Accuracy | ±(0.03% of output + 20 pA) |
| Current Sinking Accuracy | ±(0.03% of output + 20 pA) |
| Output Resolution | 100 fA |
| Output Accuracy | ±(0.03% of output + 20 pA) |
| Power Requirements | 100 V to 240 V AC, 50/60 Hz |
Outlines the manufacturer's warranty coverage for the product.
Essential safety guidelines for operating the instrument safely.
Details the triax connector and its terminals for current source output.
Explains the four configurations for connecting the triax inner shield.
Lists key specifications like current ranges, compliance limits, and output power.
Explains how the compliance setting limits output voltage and its accuracy.
Describes linear, logarithmic, and custom sweeps and their parameters.
Explains the common steps to arm Delta, Pulse Delta, and Differential Conductance tests.
Summarizes characteristics of sine, square, ramp, and arbitrary waveforms.
Explains how trigger models control sweep progression and count.
Describes how to perform limit tests to check compliance and set fail patterns.
Explains how to choose and set up GPIB, RS-232, and Ethernet interfaces.
Covers command words, parameters, and program message structure for remote control.
Explains the status byte and service request registers and their control.
Lists and explains IEEE-488.2 common commands for instrument control.
Outlines conditions, warm-up, and equipment needed for proper calibration.
Step-by-step instructions for front panel and remote calibration.
