Model 6517A Getting Started Manual Remote Operation 3-13
:RESistance Path to configure Ohms:
(Volts commands) The commands for Volts (except :GUARd)
apply.
[:AUTO] Path to configure Auto V-Source Ohms:
:RANGe Path to set measurement range:
[:UPPer] <n> Select range (0 to 100e18).
:AUTO <b> Enable or disable auto range.
:MANual Path to configure Manual V-Source Ohms:
:CRANge Path to set measurement range:
[:UPPer] <n> Select range (0 to 100e18).
:AUTO <b> Enable or disable auto range.
:VSOurce Path to control the V-Source.
[:AMPLitude] <n> Specify V-Source level (0 to 1000).
:RANGe <n> Set range; ≤100 = 100V range, >100 =
1000V range.
:OPERate <b> Enable or disable V-Source output.
:IREFerence <b> Enable or disable amps reference.
:DAMPing <b> Enable or disable damping.
:VSControl <name> Select ohms V-Source mode (MANual or
AUTO).
:MSELect <name> Select ohms type (NORMal or RESistivity).
:RESistivity Path to configure resistivity:
:STHickness <NRf> Volume — Specify sample thickness; 0.0001
to 99.9999 (mm).
:FSELect <name> Select test fixture (M8009 or USER).
:M8009 Path to query Model 8009 test fixture:
:RSWitch? Query switch setting (SURFace or
VOLume).
:USER Path to configure user test fixture.
:RSELect <name> Select test type (SURFace or VOLume).
:KSURface <NRf> Surface — Specify Ks; 0.001 to 999.999.
:KVOLume <NRf> Volume — Specify Kv; 0.001 to 999.999.
:CHARge Path to configure Coulombs:
(Volts commands) The commands for Volts (except :GUARd)
apply.
:ADIScharge Path to control auto discharge.
:LEVel <NRf> Set level (-2.2e6 to 2.2e6).
[:STATe] <b> Enable or disable auto discharge.
To Next Page
Loading...
Need help?
General
