Keithley S530 - Page 17

Section
2: Linear Parametric Test Library S530/S540 KTE Linear Parametric Test Library (LPTLib) User's Manual
2-8 S530-900-01 Rev. E / September 2017
The following commands are supported by pulse-generator unit (PGU) drivers:
•
pgu_init
• pgu_load
• pgu_current_limit
• pgu_range
• pgu_period
•
pgu_rise
•
pgu_fall
• pgu_width
• pgu_delay
• pgu_height
• pgu_offset
•
pgu_mode
•
pgu_trig_burst
• pgu_trig_unit
• pgu_trig
• pgu_halt
The following commands are supported by scope card (SCP) drivers:
•
scp_init
• scp_setup
•
scp_measure
•
scp_measure_next
• scp_detect_peaks
•
scp_selftest
•
scp_close
The following commands are supported by system drivers:
•
setmode
The following commands are supported by digital multimeter (DMM) drivers:
•
avgi
,
avgv
(
avg
X)
• clrtrg
• devclr
• getstatus
• intgi, intgv (intgX)
• lorangeX
• measi, measv (measX)
•
rangei
,
rangev
(
range
X)
• refctrl
• savgv (savgX)
• setauto
• setmode
• sintgv (sintgX)
•
smeast, smeasi,
smeasv (smeasX)
• trigtg, trigvg
(trigXg)
• trigtl, trigvl
(trigXl)
• tstsel
The following commands are supported by switch mainframe drivers:
•
addcon
• clrcon
•
conpin
•
conpth
• delcon
•
setmode
• tstsel
The following commands support timer functions:
•
disable
• enable
•
imeast
The following commands control USB instruments that are not supported by S530 or S540 drivers:
•
kibdefclr
• kibdefint
•
kibrcv
•
kibsnd
• kibspl
•
kibsplw