26
GETTING STARTED
1) Use the least number of functions possible. Do not program in functions
you do not specifi cally require, as to do so will make the system’s operation
unnecessarily complicated and may introduce unpredictable interactions
between the various functions.
2) When changing modes always start by purging the previous settings to
restore factory defaults before proceeding. This ensues no confl icts occur
between previously set functions and new functions.
3) Set realistic and sensible values into the various functions. For example,
do not set a pump to stop at a lower pressure than it is set to start at.
Always set the E30’s starting and stopping pressure differential to as wide
a difference as possible.
The E30 can control a pump or pumps in a variety of ways. The functions
are divided into sections called modes. In addition to the operating modes
the E30 includes functions common to most modes and functions specifi c
to individual modes. This document details the common functions fi rst and
then details the individual modes and the special functions.
With the E30 powered up, Press the (P) button. Hold it down for 1
second and then release it.
KELCO www.kelco.com.au
This is the fi rst screen in the menu
Press and release (P) again.
PRESSURE SWITCH MODEL E30
Displays the model number
Press and release (P) again.
VERSION 000000. The version number must match the version number
on the cover of this book.
Press and release (P) again.
USE REMOTE INPUT NO
Lets you confi gure the remote input.
Press and release (P) again.
SELECT PRESSURE UNITS: kPa. Press and release the (˅) button to
change kPa to psi. Press the (˄) button to change back to kPa.
Press and release (P) again.
SELECT A MODE PRESS P
To Next Page
Loading...
Need help?
General